Stainless steel fluid transmission pipes are welded tubes formed from stainless strip coil with welds inspected by NDT. Smooth inner and outer walls give low flow resistance and resist sediment buildup, making them a common welded pipe for water supply and drainage, chemical fluids, cooling water and equipment piping.
| Pipe type | Fluid-grade stainless welded pipe | Section | Round |
| Available materials | 304, 304L, 316L; duplex 2205, 2507 (for high-chloride, seawater and severe corrosion service) | Size range | OD Φ8–Φ219mm, wall thickness 0.4–6mm (reference, per drawing) |
| Fabrication | Cut-to-length, beveling, deburring, bending, flaring (optional) | Surface finish | Pickling passivation, bright, polished (optional) |
| Standards | GB/T 24593, GB/T 12771, ASTM A312 (as required) | Inspection | Eddy current test, hydrostatic test, dimensional and visual inspection; material and test reports issued |
| Media | Water, cooling circulation water, oil and neutral/corrosive process fluids (grade selected by service) | Delivery condition | Solution annealed, pickled (optional) |
Q: In what piping is a fluid transmission welded pipe mainly used?
A: Water supply and drainage, general chemical medium delivery, equipment fluid lines, food-grade fluid piping, environmental equipment lines, cooling water and oil transfer; grade is selected by medium corrosivity.
Q: Can grade 304 carry corrosive media?
A: 304 suits neutral water and general fluids; for acidic, high-chloride or severe corrosion service, 316L or 2205 duplex is recommended. Share your service conditions and our engineers will assist with grade selection.
Q: Is this a seamless pipe? What documentation is provided?
A: This is a stainless welded pipe inspected by NDT for fluid transmission, offering better cost-effectiveness than seamless pipe. Material certificates and eddy current reports accompany delivery; cut-to-length, deburring and beveling are supported.
CONTACT US